IBM P09N4108 Uživatelský manuál stáhnout pdf (Strana 10)

The device driver is now uninstalled. Your computer will not recognize the CD-ROM

drive when it is connected to the computer unless you reinstall the device driver.

Disconnecting and reconnecting the CD-ROM

drive

Hot plugging is supported on the connection between the USB cable and your

computer. This means that the CD-ROM drive USB cable can be disconnected from

and reconnected to your computer whether the computer is on or off.

Attention

The connection between the USB cable and the CD-ROM drive itself does not

support hot plugging. If you disconnect the USB cable from the CD-ROM drive

while the USB cable is attached to your computer, it might cause damage to the

CD-ROM drive.

To avoid damaging the CD-ROM drive, turn off the CD-ROM drive before

disconnecting the USB cable from your computer. To disconnect the CD-ROM drive

from the computer, unplug the USB cable from the computer. To reconnect the

CD-ROM drive, reconnect the USB cable to the computer.

Attention

Do not disconnect and reconnect the USB cable in rapid succession or the

CD-ROM drive might not load properly. After disconnecting the USB cable, wait

at least 10 to 20 seconds, or until the hourglass icon stops displaying, before

reconnecting the USB cable.

1-6 USB Portable CD-ROM Drive

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Žádné komentáře

IBM P09N4108 Uživatelský manuál Strana 10