IBM F50 Uživatelský manuál stáhnout pdf (Strana 81)

100

101

Press Enter when you are finished; you are required to type the password again for

verification.

If you make a mistake, press the Esc key and start again.

After you have entered and verified the password, the power-on password icon

flashes and changes to the locked position to indicate that the power-on password is

set.

If you previously had set a power-on password and want to remove it, select the

Remove icon.

Note: If you

forget

the power-on password, you have to remove the battery for at

least 30 seconds to disable this password. See Appendix B, “Replacing the

Battery” on page B-1 for details.

Attention: After you remove the battery, you must reconfigure your system (bootlist,

IP parameters, console information, support processor, etc).

A password can be set only after the system is turned off and on again.

Chapter 3. System Management Services 3-13

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 363 364

Komentáře k této Příručce

Žádné komentáře

IBM F50 Uživatelský manuál Strana 81

Komentáře k této Příručce

Související produkty a manuály pro Servery IBM F50